Manual Geladeira Electrolux Df48
• OCCURRENCE SOLUTION Moisture Forms On Inside Freezer • Weather is hot and humid, which increases internal rate of frost Walls. This is normal. • Lid is slightly open. See OCCURRENCE “Lid Problems”.
Service cord pulled out of the wall receptacle - replace. Low voltage causing compressor to cycle on overload. • Clause-Remedy Complaint. Compressor Runs Too Much or 100%. Kabhi khushi kabhie gham mp3 songs free download. Erratic control thermostat, or setting too cold - replace are reset to normal position.
Wolf DF48 Manuals & User Guides. User Manuals, Guides and Specifications for your Wolf DF48 Ranges. Database contains 1 Wolf DF48 Manuals (available for free online viewing or downloading in PDF): Technical service manual.
• Avoid Service Checklist Before calling for service, review this list. It may save you both time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE SOLUTION Freezer Does Not Run. • SOLUTION OCCURRENCE Temperature Inside Freezer is Too • Temperature control is set too warm. Turn the control to a colder setting.
Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to Electrolux Home Products. Note: This Owner’s Guide provides operating instructions for your model.
To the input of the evaporator. Refrigeration System Basic components of a freezer are: 1.
With the lid closed insert a pin or nail into the hinge remove the (4) screws holding the bottom part of to lock it closed. • Removing the Food Baskets: 2.
Freezer with insufficient power can damage the motor. Such damage is not covered under the For Your Safety warranty. • seal properly, causing cooling, frost, or moisture NOT be loaded into freezer until freezer has problems. Operated for 4 hours. To Level Chest Unit: • When loading freezer, freeze only 3 pounds of fresh food per cubic foot of freezer space at one time. Distribute packages to be frozen evenly throughout If needed, add metal or wood shims between feet pads the freezer.
Valve to charging cylinder. Run compressor for a few minutes and leak test high side. • Center port manifold hose after hand shut-off valve to vacuum pump. When leak is found, recapture refrigerant using EPA approved recovery system Repair and go back Evacuating System. When satisfied that the unit is operating correctly, clamp the high-side process tube with the pinch-off tool while the unit is still running.
Geladeiras
Using dry hoses may enter sealed systems and ul nitrogen or carbon dioxide. Timately restrict the cap tube in an R-134a system. • • Center port manifold hose before hand shut-off 7. Leak test low-side. Close compound gauge.
Allow several hours for the temperature to stabilize. • Lid is kept open too long or too frequently. Warm air enters the freezer every time the lid is opened.
Geladeira Americanas
Unless stated, reverse the procedure to reinstall the component. Raise the lid, remove the light shield and light bulb. Always remove electrical power 3. • Removing Lid Inner Liner and Seal: 5. Remove the seal by starting in the corner and lifting the seal off. The lid inner liner is held to the lid cover by (36) plastic rivets and (4) Phillips head screws that are hidden in by the seal.
• SECTION C - ELECTRICAL CIRCUITS protector is a thermal device that senses a temperature of the compressor shell and prevents damage to compressor motor by removing power if There are (5) electrical circuits in the frost-free freezer: the compressor overheats. • defrost timer is in the run mode contacts (1) to (4) At a predetermined condition, the run winding are closed and powers applied to the overload current, which is also the current through the relay protector of the compressor. Current flows through coil, drops to a value below that necessary to hold the overload protector applying powers to both up the relay armature. Defrost Timer Motor Circuit. The defrost timer motor circuit is made up of the cold control and the defrost timer motor. Whenever the cold control contacts are closed.